PTFE guide for right side mount for Troodon/Voron 2.4 supports collet clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A PTFE tube guide to prevent full spool tangles on the filament spool holder.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
If you are right-side back mounting a filament holder you need a way to feed filament into the printer. A reverse bowden setup is typical. I downloaded the one that I remixed, and it did not grip the PTFE tube but left it loosely hanging. It also was a little short for my situation where I have a smooth roller (with felt brakes) as my filament holder of choice. This remix extends the original, makes it fit the frame of a Troodon 2.0 Pro a little tighter, and gets it out over the middle of the spool instead of to one side of it. I've had disasters where a full spool unwinds on the filament holder if it isn't guided properly, so I modified this one to do a better job at a fixed guide.
Should work for any VORON where the filament holder is normally in the back right corner with the spool parallel to the back panel. I needed the spool on the right side panel, so I used a corner-spool-holder adapter (separate model) to angle my spool holder, then added this PTFE tube guide to finish the routing into the printer. The tube from the spool goes to the Filament Sensor - and then from there into the reverse bowden tube that feeds the extruder chassis.
It's an easy print - no supports required. Print as bedded in the model file, and if you open that file as a Prusa Slicer project it will setup the infill and perimeters for you ready to go.