Handlebar mount for Rad Power Bikes Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a handlebar mount for the rad power bikes headlight. Print in Nylon
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This is a headlight mount for Rad Power Bikes that allows you to mount the headlight to your handlebars, if for some reason you would need that. I used the MIKE config tool and printed in Nylon. I did a test in PLA+ and that works fine--except for the bolt sizes being not something that matched what I had in stock ( M5). I tried again in PETG Pro--that was a failure--too brittle. Nylon was clutch for this--enough flexiness to stretch the caliper part over the handlebars and also soft enough for me to embed the hex nut into the housing with simply a set of pliers. I am now using Nylon for all my bike connector parts!