Handlebar mount for Rad Power Bikes Light
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a handlebar mount for the rad power bikes headlight. Print in Nylon
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
This is a headlight mount for Rad Power Bikes that allows you to mount the headlight to your handlebars, if for some reason you would need that. I used the MIKE config tool and printed in Nylon. I did a test in PLA+ and that works fine--except for the bolt sizes being not something that matched what I had in stock ( M5). I tried again in PETG Pro--that was a failure--too brittle. Nylon was clutch for this--enough flexiness to stretch the caliper part over the handlebars and also soft enough for me to embed the hex nut into the housing with simply a set of pliers. I am now using Nylon for all my bike connector parts!