18650 with protective circuits Battery Holder Keystone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Puckis Battery Holder for 18650 with protective circuits e.g. 69x18.5 mm using Keystone 1107-1 soldering contacts
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Battery Holder for 18650 batteries equipped with safety circuits. The Battery in the picture has length x diameter 69x18.5 mm. The design is for Keystone 1107-1 soldering contacts. The battery snaps in the holder and can be pried out again carefully with a screwdriver.
The Keystone 1107-1 should be inserted 5.5 mm from the top of the print (see the picture with the caliper where this distance is measured).
Please clean the small slot (8.5x1mm) for the metalcontact, e.g. to remove strings, to avoid any stucking and bending when inserting the soldering contact.
On one side is a simple cablemanagement for up to 1.5mm² cables.
The holes are designed for M3 (diameter 3.5mm). The holes are exaktly 90 mm from center to center. The whole print is 100 mm long and 31 mm wide.
Do not use nozzles bigger than 0.4, Layer 0.2 (Quality) to print the slot for the soldering contacts exaktly. 50% infill is recomended.
The part in the pictures is printed and tested with Nobufil PCTG, colour stainless steel, and a MK3S. I dont know if it works with PLA - it should!
Check out also my 21700 battery holder. This is my favourite battery size (+50% capacity, just a bit taller).
Overengineered in Austria. Tested under harsh conditions in the alps.
Keep on printing!
Version History
V3: Initial Release
V4 (released 20251228): Additional holes in the sidewall make it easier to pry the battery out.