1 / 2
Magnetic Shrewsbury Biscuit Fidget Slider — zdjęcie 1
1 / 2

Magnetic Shrewsbury Biscuit Fidget Slider

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These shrewsbury biscuits are fun to fidget with, with embedded magnets to give it a satisfying click and snap.

Ocena
0 / 5
Polubienia
3
Pobrania
10
Wydruki
0
Wyświetlenia
90
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

You truly get all of the biscuit and none of the crumbs. Obvious disclaimer: please do not eat these, as tempting as they look!!

These shrewsbury biscuits are fun to fidget with, with embedded magnets to give it a satisfying click and snap as you slide. Each piece prints separately for easy assembly.

There is a pre-assembled .3mf file with pauses included, as well as the individual STEP files being available separately.

Extra requirements

15x 3x2mm magnets. Each piece requires 5 magnets.

Behind the model

After taste-tasting many reference images, I drew the shapes in Adobe Illustrator before transferring them into SolidWorks for the actual modelling process.

The printed model used eSun PLA+ in Red and eSun PLA Matte in Almond Yellow.

These are slightly smaller than the real bikkies, at around 43mm diameter.

Assembly

Both biscuit pieces can be printed on the same plate, with the side with the magnet holes facing the bottom of the build plate. Add a layer pause at 4.00mm to insert the magnets.

The jam requires a layer pause at 3.60m to insert the magnets.

The top biscuit and the jam should have the magnets with the same orientation. The bottom biscuit should have the reversed orientation.

EG: the top biscuit and jam magnets are inserted with NORTH facing UP, the bottom biscuit magnets are inserted with SOUTH facing UP.

Once magnets are pressed firmly into place, resume the print.

Printing tips

If using PLA in an enclosure, keep the door open to help with cooling.

If printing the multicoloured versions, make sure your flush volumes are fine-tuned.

Layer nozzle: 0.4mm

Layer height: 0.2mm

Perimeters: 2

Infill: Gyroid or adaptive cubic 10%

Tagi