Polydryer Hanger for Core One - ?x10x5 magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I adjusted Narcorex's model so that magnets that are actually ?x10x5mm fit, and to remove holes so it prints faster.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the best holder I've found for hanging a Polydryer box off my Core One. I made a few changes to Narcorex's model to make it fit my magnets and print faster (see differences section).
When printing, be careful since the model is long and thin enough that it likes to start warping. It may be easier to split into two interlocking pieces with Prusa Slicer and print that way.
I used two 20x10x5mm magnets for each hole, but as long as our magnets have an end profile of 10x5mm you'll be fine.
I bought my magnets from Amazon US: https://www.amazon.com/dp/B0D9NHTWGM