1 / 1
Polydryer Hanger for Core One - ?x10x5 magnets — image 1

Polydryer Hanger for Core One - ?x10x5 magnets

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I adjusted Narcorex's model so that magnets that are actually ?x10x5mm fit, and to remove holes so it prints faster.

Rating
0 / 5
Likes
5
Downloads
19
Makes
0
Views
286
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is the best holder I've found for hanging a Polydryer box off my Core One. I made a few changes to Narcorex's model to make it fit my magnets and print faster (see differences section).

When printing, be careful since the model is long and thin enough that it likes to start warping. It may be easier to split into two interlocking pieces with Prusa Slicer and print that way.

I used two 20x10x5mm magnets for each hole, but as long as our magnets have an end profile of 10x5mm you'll be fine.

I bought my magnets from Amazon US: https://www.amazon.com/dp/B0D9NHTWGM

Tags