1 / 3
RAK 19007/4631 WisBlock antenna connector holder — zdjęcie 1
1 / 3

RAK 19007/4631 WisBlock antenna connector holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

RAK 19007/4631 WisBlock antenna connector holder downerer

Ocena
0 / 5
Polubienia
8
Pobrania
60
Wydruki
0
Wyświetlenia
398
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Those tiny IPX connectors on RAK 19007/4631 meshtastic devices can pop loose if you wiggle the antenna wire the wrong way, so I made this little tray to put the WisBlock in, with a top that goes over the antenna connector to keep it pressed down and prevent it from disconnecting. A holder downerer!

There are 3 versions.

A - is a glue on version. You put the WisBlock in it, screw it into the tray with 1-4 screws (optional) and glue the top on. This is probably best for tight installs.

B - is a little fatter and you attach the top with a screw or a bolt and nut (M3x16mm bolt and m3 nut). You could also glue this one on, the larger surface area would glue better, but I made it for bolts.

C - doesn't require you to screw the WisBlock to the tray, it has stops at the front and back to keep the WisBlock from moving in those directions, then you can screw, bolt or glue the top on.

To be honest, the WisBlock fits tight enough in all three of them that it doesn't really need to be screwed down into any of them. None of them have much advantage over the other. I've been using C on my devices but I uploaded the other two in case someone needs a smaller one for a tight install or something.

Tagi