1 / 9
Offline Crypto Wallet Backup on Stainless Steel Washers - 3mm Stamping Jig — zdjęcie 1
1 / 9

Offline Crypto Wallet Backup on Stainless Steel Washers - 3mm Stamping Jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A DIY 3mm stamping jig for creating low-cost, stainless steel washer backups of crypto seed phrases.

Ocena
0 / 5
Polubienia
6
Pobrania
33
Wydruki
0
Wyświetlenia
401
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

Paper backups fail. Ink fades. Hardware wallets break.
This 3mm stamping jig is designed to help you create a durable, offline backup of a 12–24 word crypto seed phrase (or any critical secret) by stamping directly into stainless steel washers.

This project was built to be a DIY alternative to expensive commercial metal backups (often sold for hundreds of dollars), while still delivering precision, repeatability, and long-term durability.

How It Works

Each washer is stamped using a guided layout:

  • Index markers at the top identify the word position (1–24)

  • Up to 8 characters at the bottom store the word itself

    • For BIP-39 wallets, only the first 4 letters of each word are required, making this system compact and efficient

The jig ensures:

  • Maintain proper alignment, even for re-hammers.

  • Consistent spacing

  • More professional results

Key Features
  • Designed for 3mm (1/8") metal stamping sets

  • Supports washer-based backups (easy to store, reorder, and transport)

  • Clear index digits for phrase ordering

  • Compact character layout optimized for BIP-39 seed phrases

  • Works with standard hardware store parts

  • Fully offline, no electronics, no firmware, no trust required

Why Washers?
  • Stainless steel is fireproof, waterproof, corrosion-resistant

  • Washers are inexpensive, widely available, and easy to replace

  • Individual pieces reduce single-point-of-failure risks

  • Can be stored on a single bolt or split into multiple locations

Printing Recommendations

Tested successfully with:

  • Printer: Bambu P1S

  • Layer Height: 0.2mm (Strength preset)

  • Walls / Top / Bottom: 4 layers

  • Infill: Gyroid, 25%

  • Top Layer Ironing: Enabled (purely cosmetic, optional)

Materials Needed

  • 3mm (1/8") Letter & Number Metal Stamping Set (6mm characters recommended)

    • Tested with: Owden 36-piece Number & Letter Stamping Set

  • 14× Stainless Steel Washers

    • 5/16" or 3/8"

  • 1× Bolt

    • 5/16" or 3/8", ~1.5"-2" length

  • 1× Matching Nut

Stamping Set Links:

Owden: https://www.owdencraft.com/products/number-and-uppercase-letter-metal-stamps-1-8
Amazon CA: https://a.co/d/1rVAyzt
Amazon US: https://a.co/d/2UPT4re

Disclaimer

This jig is a tool, not a security guarantee. Always verify your stamped backup, test recovery procedures, and follow best practices for physical security and redundancy. Never take or post pictures of your backup.

Tagi