Adhesive band (Tesafilm) replacement roll
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Because those rolls tend to break very easily here is a replacement with the exact same measurements.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The roll comes in two files, because I didn't want to print with supports.
Those were my print settings for the drum (but anything remotely sane should work as well):
PLA
Quality
0.4mm nozzle
0.2mm layer height
wall printing order: inner/outer/inner
only one wall on top surfaces UNchecked
Strength
3 wall loops
5 top shell layers
Top surface pattern: Concentric
5 bottom layers
Bottom surface pattern: Concentric
Infill density: 20%
Infill pattern: Gyroid
Fuzzy skin
Those were the print settings for the pin:
PLA
Quality
0.4mm nozzle
0.2mm layer height
Strength
2 top shell layers
Top surface pattern: Concentric
2 bottom layers
Bottom surface pattern: Concentric
Infill density: 50%
Infill pattern: Rectilinear
Brim
Type: outer brim only
width: 2mm
gap: 0.12mm
In the end I hammered both together.