AIRSOFT Stock for Cyma AKM

Here is a stock with battery compartment for the old Cyma CM036 AKM.

It may be suitable for other Cyma AKs (or other brands) if they have the same attachment system. I am attaching a photo so you can compare it with the attachment on your replica.
It is mainly attached with the four screws located on each side of the battery cable passage to the stock. These four screws secure the stock to the body of the AKM.

The Picatinny rail for attaching a strap can be placed on the left or right side, as you wish.

Even if the top and bottom brackets are broken (which happens very often on these models), this stock fits perfectly!

What you will need:

• 2 x M3x16 (Picatinny rail stock attachment);

• 2 x M3x12 (stock attachment);

• 2 x M4x16 (butt plate);

• 1 x M3x6 (cover latch);

• 1 x spring between 4.5mm and 6mm in diameter and 25mm long maximum (for the latch);

• and the 3 original M4 screws if the top and bottom brackets are still present.

I use PETG-CF, 0.4 mm nozzle, 0.2 mm layer. Use a robust print configuration: 6 shells and 50% honeycomb infill for the stock itself.

You can also use ABS or ASA for their strength. For PLA or PLA+, I cannot guarantee the strength in play!!!

No support is required for printing the stock, butt plate, and Picatinny rail. Support is required for the cover and latch.
All files are in the correct printing orientation.

In the last photo, you can see the complete restoration of my CM036:

• - the stock (my own design);

• - the AK105-type front sight (my own design);

• - the handguard/upper with AK200-type Picatinny rail (here https://cults3d.com/:108757, but modified for the CM036);

• - the flash hider (https://cults3d.com/:23842 also modified to be attached to the CM036).

Please share your impressions and comments!!!