1 / 8
Ulefone Armor 28 (in TPU case) car holder horizontal and vertical including Brodit version — zdjęcie 1
1 / 8

Ulefone Armor 28 (in TPU case) car holder horizontal and vertical including Brodit version

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ulefone Armor 28 car holder. Meant for Armor 28 in TPU case.

Ocena
5 / 5
Polubienia
4
Pobrania
25
Wydruki
0
Wyświetlenia
204
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

Ulefone Armor 28 car holder. Meant for Armor 28 in TPU case.

It is just the holder without any mounts for the dashboard.

Several holes in the back can be used to screw the holder to whatever you use to put the holder on.

This is my second model for an Ulefone Armor phone

I previously used an Ulefone Armor 18T. This phone uses nearly the same model holder I created. The 28 is slightly thicker.

So I changed some dimensions to get the 28T to fit.

In case of 'emergency' the 18T will also stay in this holder (but has a little room for movement without falling out)

The previous (nearly the same) model survived 1½ years without any problems but is replaced because of a new phone.

Printed in PETG

0.6mm nozzle

50% infill

0.32mm layer height 

No supports needed except for the vertical Brodit version. This one just needs supports in the 4 mounting holes.

Horizontal Brodit version with 5cm 'feet' must be printed laying flat with supports enabled.

Horizontal Brodit version without 'feet' must have supports for the Brodit/HR Rigter connection parts.

Tagi