1 / 2
Gaggiuino Gen 3 Headless Unofficial ESP32-S3-N16R8 case — zdjęcie 1
1 / 2

Gaggiuino Gen 3 Headless Unofficial ESP32-S3-N16R8 case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For those who went the rough way of avoiding the official Gaggiuino HW and opted for a4vgx7b2M 'hacked' FW

Ocena
0 / 5
Polubienia
2
Pobrania
32
Wydruki
0
Wyświetlenia
538
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial

Case for headless mod of Gaggiuino which uses the 'hacked' FW from https://github.com/a4vgx7b2M/gaggiuino-esp32-loader.

Will hold the ESP32-S3 devkit (e.g here), JST XH 4pin male header (here), and SD car reader without voltage regulator (here).

Reason I opted to use JST XH over JST PH that the official headless board uses, is so that the original cabling I had used on my Gaggiuino Gen2 with Nextion Screen could be reused straight away.

For optimal results print with layer height of 0.15mm or less. I printed in PLA, though other materials might work as well.

Original onshape project here, in case you need to adjust board height or dimensions slightly for your use.

Wiring:

ESP32-S3 Pin

SD Card Reader Pin

GND

GND

13

MISO

12

CLK

11

MOSI

10

CS

3.3V

3.3V

ESP32-S3 Pin

Blackpill

GND

GND

TX (pin 17)

RX (pin A3)

RX (pin 18)

TX (pin A2)

5V

5V

Pin definitions for reference:

Soldering note: The picture shows wires soldered from the top, however, the latest version of the model requires you to solder wires from the bottom of the board.

Tagi