1 / 2
Gaggiuino Gen 3 Headless Unofficial ESP32-S3-N16R8 case — image 1
1 / 2

Gaggiuino Gen 3 Headless Unofficial ESP32-S3-N16R8 case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For those who went the rough way of avoiding the official Gaggiuino HW and opted for a4vgx7b2M 'hacked' FW

Rating
0 / 5
Likes
2
Downloads
32
Makes
0
Views
538
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Case for headless mod of Gaggiuino which uses the 'hacked' FW from https://github.com/a4vgx7b2M/gaggiuino-esp32-loader.

Will hold the ESP32-S3 devkit (e.g here), JST XH 4pin male header (here), and SD car reader without voltage regulator (here).

Reason I opted to use JST XH over JST PH that the official headless board uses, is so that the original cabling I had used on my Gaggiuino Gen2 with Nextion Screen could be reused straight away.

For optimal results print with layer height of 0.15mm or less. I printed in PLA, though other materials might work as well.

Original onshape project here, in case you need to adjust board height or dimensions slightly for your use.

Wiring:

ESP32-S3 Pin

SD Card Reader Pin

GND

GND

13

MISO

12

CLK

11

MOSI

10

CS

3.3V

3.3V

ESP32-S3 Pin

Blackpill

GND

GND

TX (pin 17)

RX (pin A3)

RX (pin 18)

TX (pin A2)

5V

5V

Pin definitions for reference:

Soldering note: The picture shows wires soldered from the top, however, the latest version of the model requires you to solder wires from the bottom of the board.

Tags