1 / 2
Water key seals for instruments like a trumpet — zdjęcie 1
1 / 2

Water key seals for instruments like a trumpet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The original cork on the water key was badly deformed and no longer sealed properly, so I designed this set of water‑key

Ocena
0 / 5
Polubienia
3
Pobrania
15
Wydruki
0
Wyświetlenia
134
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial

The seal is made from ColorFabb Varioshore. I set the print parameters to make it as soft as possible for the best sealing effect. It has been in use for over a year now, has only slight pressure marks, and still seals perfectly. Even though I had doubts at first, the printed seal has proven to be a better choice than the usual cork ones.

In case the water‑key seal ever fails during a gig, I printed a little seal kit so I can replace it or help out a colleague.

Settings for ColorFabb Varioshore:

Parameter

Value

Extrusion Multiplier

0.65

Material Density

1.22 g/cm³

Idle Temperature

70 °C

Nozzle Temperature

First Layer: 250 °C

 

Other Layers: 250 °C

Bed Temperature

First Layer: 80 °C

 

Other Layers: 80 °C

Print instruction:
  • material: flexible filament

  • supports: no

  • layer height: 0,2mm ... 0,3mm

  • nozzle diameter: 0,4mm or 0,6mm

  • brim: not required

  • enclosure: not required

Tagi