1 / 4
Tennis Ball Rocker Feet for Wahoo KICKR CORE 2 (Low Profile) — zdjęcie 1
1 / 4

Tennis Ball Rocker Feet for Wahoo KICKR CORE 2 (Low Profile)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Low profile rocker feet for the Wahoo KICKR CORE 2 that work with a 700c x 32mm-ish front tire without a riser block.

Ocena
5 / 5
Polubienia
28
Pobrania
544
Wydruki
2
Wyświetlenia
2687
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Indoor Sports
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

About

This is a set of replacement feet for the Wahoo Fitness KICKR CORE 2 Smart Trainer which hold tennis balls to allow the trainer to rock and move slightly while riding. This can reduce fatigue and lead to longer rides and more comfort.

My version is a low-profile design. Many of the other tennis ball feet lift the bike further off the ground, necessitating a front wheel riser block to level the bike and achieve a good fit. For a typical modern road bike.

Estimating a 5mm sag (squish of tennis balls) during use, this is the equivalent of adding 15mm of lift to the rear of the bike (with something like my Wahoo Fitness KICKR CORE 2 Riser Feet). This makes a bike with a 700c x 32mm (or so) front tire -- typical for many endurance road bikes -- level during use.

Printing

The attached .3mf from Bambu Studio shows the exact print settings I used with Overture PETG in Black. This is six walls, 25% gyroid infill, and a very low and higher temperature speed print for a nice, shiny finish and good layer adhesion. I suggest using a high print bed temperature (85°C - 90°C) to ensure good adhesion. With this set low a bit of warping may occur.

The .3mf was created from the .step file. While I've provided an .stl, it's lower resolution than what I printed. The higher resolution makes for smoother curves around the tennis ball and a nicer finished print.

If you print this with PLA or another plastic or settings, please let me know your results and how it's held up for you.

Installation

These feet replace the stock rubber feet. Remove the retention screws with a 3mm hex wrench, slide the original feet off, slip these in, and put the screw back in. Pop some tennis balls into the feet and you're ready to ride.

Thanks to Jake!

Big, big thanks to Jake Drews over at Cycl3d for helping me out with learning Fusion and getting better at designing and producing decent prints. If you are looking to buy some tennis ball rocker feet (or other Michigan / US made trainer accessories), give him your business.

His trainer feet inspired me to learn a bit more about drawing and seeing if I could make my own version, and this is what I came up with.

Tagi