Centauri Carbon Cradle for Chitu Mini Heater H2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Basic mount for the Chitu Mini Heater
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 241
- Wydruki
- 2
- Wyświetlenia
- 1696
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Description
Here is a mounting solution for Chitu Systems Mini Heater H2 inside the Centauri Carbon.
Installation
This mounts to the M3 threaded hole located on the left side of the printers base. I used Fleeeinlan3D's version of SE3D's 7.5mm panel spacer to bump out the left side panel so I could route the power and control cables outside of the printer. The wire relief they added worked out nicely.
Since I had to use M3x12 screws to mount the spacer, I used one of the stock M3x4 screws that were replaced to fasten the cradle. The threaded hole at the base of the printer has something below it requiring a short screw.
If you have a different solution for routing the cables or can't get your hands on a M3x4 screw, I've uploaded a step file so you can adjust the mounting tab thickness to work with what you have for screw lengths.