Adaptive bed mesh for Orca Slicer and Klipper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adaptive bed mesh for Orca Slicer and Klipper, tested with sovol sv07 and sv07plus
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
; hack-fix: write fake slicer info here so that preprocess_cancellation can process.
; generated by SuperSlicer 1.5.0 on 2023-04-21 at 13:13:47
M84 E ; Disable E Motor for probe accuracy on direct drive systems
G90 ; Absolute positioning
M117 Warming Bed
M140 S[bed_temperature_initial_layer_single] ; Warm bed without wait for temperature
M117 Warming Hot-End at 150 celsius for avoid oozing
M104 S150
M117 Home XYZ axes
G28
M117 Calculating Z_TILT_ADJUST...
Z_TILT_ADJUST
M117 Waiting for bed temperature...
M190 S[bed_temperature_initial_layer_single]
M117 Warming Hot-End at 165 celsius
M104 S165
M117 Calculating Adaptive Mesh...
; Always pass ADAPTIVE_MARGIN=0 because Orca has already handled adaptive_bed_mesh_margin internally
; Make sure to set ADAPTIVE to 0 otherwise Klipper will use it's own adaptive bed mesh logic
BED_MESH_CALIBRATE mesh_min={adaptive_bed_mesh_min[0]},{adaptive_bed_mesh_min[1]} mesh_max={adaptive_bed_mesh_max[0]},{adaptive_bed_mesh_max[1]} ALGORITHM=[bed_mesh_algo] PROBE_COUNT={bed_mesh_probe_count[0]},{bed_mesh_probe_count[1]} ADAPTIVE=0 ADAPTIVE_MARGIN=0
M117 Adaptive Mesh Done.
...
Put this code at start g-code of machine, find x-y min and max points (from printer.cfg) and set it up in adaptive bed mesh section, check label objects in others section and that's all, enjoy!
Tested with sovol sv07 and sv07plus, min and max points for sv07 are mesh_min: 11,12 mesh_max: 210,205 and for sv07plus are mesh_min:17,15 mesh_max:285,282, you can find out these values at bed_mesh section in your printer.cfg.