1 / 2
Dust hood for router table (for 35, 38, 50 and 100 mm)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hood to collect the dust when using a flush trim bit. For a 35mm shop vac adapter.
- Ocena
- 5 / 5
- Polubienia
- 84
- Pobrania
- 239
- Wydruki
- 1
- Wyświetlenia
- 968
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (113)Powiązane
My try for a practical solution to collect dust.
Print in PETG should be fine.
No support needed and print standing on the vac inlet side.
I made a few different sizes, but only tested the 35mm Version. So some feedback would be nice!
If you need a specific hole diameter for your vac, just give me some measurements...