1 / 2
Dust hood for router table (for 35, 38, 50 and 100 mm)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A hood to collect the dust when using a flush trim bit. For a 35mm shop vac adapter.
- Rating
- 5 / 5
- Likes
- 84
- Downloads
- 241
- Makes
- 1
- Views
- 980
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
My try for a practical solution to collect dust.
Print in PETG should be fine.
No support needed and print standing on the vac inlet side.
I made a few different sizes, but only tested the 35mm Version. So some feedback would be nice!
If you need a specific hole diameter for your vac, just give me some measurements...