Mateksys H743 V2 Snap Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print is a solid self-snapping mount for the Mateksys H743 Wing V2.It can be hot glued into foam planes, or it…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This print is a solid self-snapping mount for the Mateksys H743 Wing V2.
It can be hot glued into foam planes, or it can be screwed into wood planes with a US #4 wood screw or similar.
The top lid securely snaps into the base, but can be separated again with a bit of force. It is designed to remain secure in flight, but not require so much force to open that the base would come unglued. This allows for the Wing V2 to be removed and worked on then returned to the aircraft.
If snapping ever becomes too loose (due to repeated opening and closing), simply reprint the top lid.
Print Settings
Printer:
Prusa Mini+
Rafts:
Doesn't Matter
Supports:
No
Resolution:
1.5 mm
Infill:
20%
Notes:
Two ways to print:
- SnapMount.3mf - A Prusa Slicer project ready to print both halves with the recommended settings below.
- Bottom.stl and Top.stl - The two STL halves without any parameters (see recommended settings below).
Recommended settings
For this model PLA is not recommend since the snap joints will wear out more quickly. PETG is preferred.
I recommend a layer height of 0.15 mm to help round out the snap joints and 20% infill is sufficient. No supports are necessary.
How I Designed This
The Fusion 360 design file is included. It'sH743V2SnapMount.f3d and is fully parametric. For more information see the GitHub Page
Category: R/C Vehicles