IKEA KALERUM (305.536.50) Drill Guide – PAX Door Handle Template (256 mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This 3D-printable drill guide is made for installing the IKEA KALERUM handle (305.536.50) on IKEA PAX doors with clean,
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 393
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
IKEA KALERUM (305.536.50) Drill Guide – PAX Door Handle Template (256 mm)
This 3D-printable drill guide is made for installing the IKEA KALERUM handle (305.536.50) on IKEA PAX doors with clean, repeatable results. It sets the two handle holes at 256 mm center-to-center and positions the handle at the correct height—no measuring each door, no crooked handles.
Positioning (PAX door reference)
Measure from the top edge of the PAX door straight down.
Place the guide so the upper edge of the drill guide sits 1012 mm below the top of the door.
Align the guide to the door edge as designed (left/right), clamp if possible, then drill.
What it does
Locks in hole spacing (256 mm) for the KALERUM handle
Gives consistent placement across multiple doors
Helps keep holes straight and handles perfectly level
Print recommendations
Material: PETG
0.2 mm layers
3–4 walls/perimeters
5-10% infill
Print flat for best dimensional accuracy
Use tips
Start with a small pilot hole if you want extra precision, then drill to final size.
Always test once on scrap or an inside face to confirm your printer tolerance and drill bit fit.