IKEA Skadis for Drona Boxes (STEP files included!)

Description

This is a clip-on IKEA Skadis plate that attaches to the side of your Drona boxes, so you can make use of that empty wasted space.

For a less-extreme solution to using the side space of your Drona boxes, I have also made a simpler clip-on box for Drona boxes.

What you'll need

The model is two parts, a clip-on part that attaches to the Drona box, and the Skadis plate that attaches to the clip. 

To attach the two parts, you will need

• 2 x M3x10mm screws

• 2 x M3 nuts

Printing Advice

Drona-side clip

For maximum strength, I suggest printing this clip up right as shown below (this way, the clip will experience tension along layer lines, so layer adhesion isn't the limiting factor).

No supports needed.

I used 3 walls, 10% gyroid infill, 0.25 mm Speed profile on my MK4S w/ 0.4 mm HF nozzle.

Also, I recommend using a brim, even if printing PETG on a PEI sheet (crazy adhesion), unless you want the following to happen (black: PLA - pink: PETG)

Although, I could probably sell this to an art museum to make up for the lost material.

Skadis plate

Print this with the two cylindrical protrusions pointing up

I didn't use supports for the screw holes which have a recess region for the caps of the screws to hide in, and sit flush against the surface.

I printed 2 walls, 15% gyroid infill, 0.25 mm Speed profile.

Assembly

Place two M3 nuts in the slots intended for them in the clip-on part, you can see these below

Then, screw the Skadis on to the clip with M3 screws as seen below.

You're ready to clip it on to your Drona box.

Combining for Wider Plate 

You can attach two of these side by side. You can use a Skadis attachment plate that you attach to both plates to lock them together, below, I have attached one of these caliper holders:

The model for this caliper holder is below