Accordion Door Hangers - Repair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The accordion door hangers tore out of the door. This will replace the hangers using double sided foam tape.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
This is designed for the LTL Home Products HSR3680H Regent Interior Accordion Folding Door.
https://www.amazon.com/dp/B00MLZKPN4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5&th=1
These are designed to be printed flat, I printed mine from recycled PET with a .6 nozzle at .3 layer height. I suggest a finer layer height so it will allow the hangers to slide more readily. Note, the seem should be avoided around the neck of the hangers and specified to be on top. The image below shows how I painted my seems in ORCA slicer.

With the middle hanger face down on a flat surface apply double sided foam tape. The tape should be 1/2" (12.7mm) wide and 1" (25.4mm) long.

The middle hangers can then be applied to the door, use the hole to help center it. If they are not centered it will bind when trying to close the door.

The end hanger should be self explanitory, you can only install it through the hole but make sure the flat side is the same as the middle hangers.