Sovol SV06 Plus BTT Eddy mount for V6 type volcano nozzle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for BigTreeTech Eddy probe, for shorter volcano nozzle
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Every mount for SV06 Plus that I've found was for the original 23.5mm nozzle. As I've switched long time ago to the shorter V6 type volcano nozzle (21mm), the Eddy probe was sitting too low.
Decided to remix Chinchill's design, as it seemed easiest to shorten cleanly. After cutting 2.55mm probing and tap works flawlessly with eddy-ng firmware.
Printed with PETG:
4 perimeters
30% infill
0.2mm layer height.
I've also mounted the probe front-faced to the extruder - according to BTT Eddy wiki this is better for the probe electronics:
Due to that, my probe offsets in the config are:
x_offset: 24
y_offset: -23