Last Meter Building Blocks - Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Quinlan's building blocks to use up your last lengths of filament. This remix tighten gaps between pieces.
- Ocena
- 3 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 1
- Wyświetlenia
- 142
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
Last Meter Brick - Remix
This is a remix of Quinlan's Last Meter Bricks. I've added the STEP file that I recreated the brick from.
Each building block takes ~one meter or less of filament to print depending on settings. The blocks snap every 45 degrees allowing you to round out corners and imply curves in your buildings.
 |  |
|---|
Setup
I generally have a file that will print 9 of them in sequential mode so I don't waste a full plate when I underestimate how much I have left in that spool.
Print Parameters
Layer Height: 0.2mm
Infill: 15% Cubic
Perimeters: 2
Default Top Infill: Monotonic Lines
Topmost Infill (modifier): Concentric
Nothing crazy here. The top infills are purely for aesthetics.