Last Meter Building Blocks - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Quinlan's building blocks to use up your last lengths of filament. This remix tighten gaps between pieces.
- Rating
- 3 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 1
- Views
- 142
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Attribution — Noncommercial
Last Meter Brick - Remix
This is a remix of Quinlan's Last Meter Bricks. I've added the STEP file that I recreated the brick from.
Each building block takes ~one meter or less of filament to print depending on settings. The blocks snap every 45 degrees allowing you to round out corners and imply curves in your buildings.
 |  |
|---|
Setup
I generally have a file that will print 9 of them in sequential mode so I don't waste a full plate when I underestimate how much I have left in that spool.
Print Parameters
Layer Height: 0.2mm
Infill: 15% Cubic
Perimeters: 2
Default Top Infill: Monotonic Lines
Topmost Infill (modifier): Concentric
Nothing crazy here. The top infills are purely for aesthetics.