Creality K2 Plus Lead Screw Debris Guards with Taper

I created these early on for two reasons; cleaning out filament debris from the small cavity surrounding the leadscrew rotation area at the bottom of the printer was tedious. As well if any instance of filament strands or dirt getting pulled into the bearing of the leadscrew motor (Pretty unlikely though). 

I Printed these from ASA for heat resistance when using the heated chamber and the ease of support removal vs Nylon or PC. I suggest you do the same but if not just be mindful of having tuned supports; for reference I used Creality's default support settings "From Build Plate Only" and had perfect parts come off, for the K2 Plus.

If you have any comments please let me know. I made the tolerances kind of tight around the leadscrew and the dove-tails. As well, I put a 0.5mm clearance for the cover and the leadscrew OD, so if these spin with the leadscrew, just hold them down and move the bed up and down a few times to wear them in to stop spinning with the leadscrew.

Thanks and happy printing!