Compartmented tool caddy for Tipton Gun Butler

This is a tool caddy for cleaning supplies that fit into the Tipton Gun Butler's large compartment and use the existing two screw holes.  The model is printed on my Prusa XL (I had to slice off the four corners to get it to fit on the build plate). 

The filament used is PLA, Polymaker PolyLite, Steel Gray color.  It takes 21 hours to print with 15% fill using 500g of filament and there were no issues during the printing process.   To remove from the build plate:  remove the build plate from the printer, then remove (peal) the build plate from the part.

The compartments are sized for:

• Hoppes cleaning fluid (3)

• Beretta oil bottles (2)

• 12 Ga bore cleaning brush (3)

• Beretta choke tube wrench (3)

• Tubes of choke lube (2)

• Beretta A400 action lever (3)

• Hoppes oil bottles (to refill the Beretta oil bottles)  (2)

• Tubes of gun grease  (3)

• Purell hand sanitizer  (2)

The SCAD file has all of the dimensions parameterized so it is easy to change for your specific bottles.

The two holes in the middle align with the Tipton Gun Butler's existing two holes.  M6 allen head socket screws work fine with M6 nuts.  Make sure that your two Tipton holes are in the same place as mine before printing.  My Tipton holes are left/right  front/back centered but I do have several millimeters of slop in the printed part just in case the holes are a tad off.

The only drawback is that I have the lube and grease tubes positioned UP instead of DOWN; but I didn't think about that until after it was finished.