Compartmented tool caddy for Tipton Gun Butler
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€25.48 – €31.14 net (excluding VAT)
For file: caddy_v2.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €28.31 excluding VAT (range midpoint).
- Weight reported by the author
- 497 g
- Print time reported by the author
- 21.47 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Compartments for various gun cleaning supplies that screws into the existing two holes in the Tipton Gun Butler.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
This is a tool caddy for cleaning supplies that fit into the Tipton Gun Butler's large compartment and use the existing two screw holes. The model is printed on my Prusa XL (I had to slice off the four corners to get it to fit on the build plate).
The filament used is PLA, Polymaker PolyLite, Steel Gray color. It takes 21 hours to print with 15% fill using 500g of filament and there were no issues during the printing process. To remove from the build plate: remove the build plate from the printer, then remove (peal) the build plate from the part.
The compartments are sized for:
Hoppes cleaning fluid (3)
Beretta oil bottles (2)
12 Ga bore cleaning brush (3)
Beretta choke tube wrench (3)
Tubes of choke lube (2)
Beretta A400 action lever (3)
Hoppes oil bottles (to refill the Beretta oil bottles) (2)
Tubes of gun grease (3)
Purell hand sanitizer (2)
The SCAD file has all of the dimensions parameterized so it is easy to change for your specific bottles.
The two holes in the middle align with the Tipton Gun Butler's existing two holes. M6 allen head socket screws work fine with M6 nuts. Make sure that your two Tipton holes are in the same place as mine before printing. My Tipton holes are left/right front/back centered but I do have several millimeters of slop in the printed part just in case the holes are a tad off.
The only drawback is that I have the lube and grease tubes positioned UP instead of DOWN; but I didn't think about that until after it was finished.