1 / 2
First Layer Calibration and Live Z in 5 minutes
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the most important first print you need to print. It will allow you to Live adjust Z Hight.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 607
- Wydruki
- 5
- Wyświetlenia
- 2643
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 5) (Komentarze: 10)Remiksy (0)Kolekcje (59)Powiązane
This is the most important first print you need to print.
It will allow you to Live adjust Z Hight.
Very short print.
In 5 minutes you will set the printer to print beautiful models.
It is set to test PLA or PETG.
If you use the stl, please use the settings as pictured so it will start printing near you and inside.
The bottom of the picture is correct height.
Just above is too high
Above that is too low
and top is almost OK
Good Luck