1987-1996 Jeep Cherokee XJ third brake light

This is a third brake light assembly I designed around a cob led strip light to replace the dated OEM light. I tossed mine when I stripped my interior and wanted to design my own so here's what I came up with. I printed this in ABS CF as pictured, abs or asa would probably be ideal especially in hotter climates. The bracket allows tilt and height adjustment for the led channel if you need it. 

I printed mine in the orientation shown with supports, 2 walls, 20% infil.

STEP and STL files included.

Three pieces in the file

• bracket that bolts into the existing holes in the rear hatch for the OEM third brake light (with supports as shown)

• LED channel that holds the LED strip (with supports as shown)

• wire cover that slides into place on the short section of the LED channel

Hardware/Parts

• 2x M4 x 12mm screws

• 2x M4 washers & 2x M4 lock washers

• 2x M4 x 4mm x 6mm brass insert (insert as shown)

• 2x sheet metal screws to bolt the bracket into place (you can reuse the original ones if you have them)

• 3M double sided tape - I lined the inside of the channel with this before I put the LED strip in place

• COB LED strip - cut it down to length - you can see the cut lines on the back of the strip while its lit up so you'll know where to cut (be sure to cut it as straight as possible or the end will look goofy when you lay it in the channel)