LIAN LI LANCOOL 207 FILTER
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear magnet filter for bottom intake 120mm fans.Easy to remove. With nylon filter net.For LIAN LI LANCOOL 207.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 302
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Removable magnet filter for Lian Li Lancool 207.
This filter covers big holes from behind the case. Stop dust intake by 2x120mm bottom fans. Easy to install and remove.
BOM:
29x round magnets (5 mm - diameter, 1 mm - heigh)
nylon filter net (approximate 80 mesh)
(optional) foam spool
Print setup:
Nozzle: 0.4 mm Layer heigh: 0.2 mm Infill: 100% Filament: PLA, PETG, etc.
Steps:
Orientate the model in slicer like in the first picture.
After slicing the model add a pause in the 7 layer (after the 7 layer finished).
When print is paused. Put magnets in holes. They should slide in without friction.
Stretch the nylon net on top of print using magnets. (Its fine if net doesnt stretched perfectly in the middle. But net should be in contact with print).
Resume the print.
Cut off excess net.
(Optional) Glue the foam for better seal.
Installation: Remove right case panel and put filter inside the case. Lean to hexagone grid.
