LayersFactory
Zgłoś model
1 / 11
Filament Spool Holder with Case for Ikea Skadis — zdjęcie 1
1 / 11

Filament Spool Holder with Case for Ikea Skadis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slin

Slin

@Slin_3996485

A simple filament spool case to attach to the skadis.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
56
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (2)Powiązane

This model is a protective filament spool case designed for the IKEA Skådis pegboard, specifically made for SUNLU V3 spools with a 200 mm diameter.

The enclosure keeps the filament fully inaccessible, which is especially useful if you have cats or pets that like to play with loose filament 🐱🧶.

If you have any questions, feedback, or improvement ideas, feel free to reach out. I’m also happy to implement custom requests if possible.

Design Notes

The base case is intentionally a bit short, so an additional spacer model is included.
This allows you to adjust the depth freely depending on your needs.

You can:

  • Glue the base and spacer together

  • Or assemble both parts directly in your slicer

Required Hardware

  • M8 threaded rod

  • 2× M8 washers

  • 2× M8 nuts

  • 4× M5 × 20 mm screws

  • 4× M5 nuts

  • 4× M5 washers

  • A short piece of PTFE tube

Assembly Instructions

  1. Pay attention to orientation:
    The M8 hole must be flush with the lower Skådis hole.

  2. Tighten the M5 screws, then drill out the M8 hole if necessary.

  3. Insert a filament spool and adjust the housing depth using the spacer as needed.

  4. You may have to drill out the hole in the top of the case so that it fits nicely onto the threaded rod. I can also upload another version where the hole is a bit bigger.

Print Settings

  • Mounting plates:
    Printed in ABS with high infill, but other materials should also work.

  • Housing & lid:
    Printed in PLA with 4 wall loops.

Used / Compatible Models

This design works together with the following excellent models:

Tagi

spoolikeacasespoolholderfilamentspoolholderfilamentcaseskadisikeaskadisspoolcasesunlutcliptclipsystem