1 / 4
Prusa Core One Rubber Feet Holder (No Adhesive) — zdjęcie 1
1 / 4

Prusa Core One Rubber Feet Holder (No Adhesive)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slim and low-profile holder for the original Prusa Core One rubber feed that firmly secures them without using adhesive.

Ocena
5 / 5
Polubienia
113
Pobrania
349
Wydruki
19
Wyświetlenia
1485
Oceny
17

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Prusa Core One Rubber Foot Holder – Adhesive‑Free Upgrade

The adhesive on the Prusa Core One’s rubber feet has always been an annoyance for me, and with some inspiration from Prusa Core One Feet v2 - Prusa rubber feet reuse by Ondrashek, I went about designing a low-profile and sleek-looking holder.

Instead of relying on the stock adhesive, this holder locks each foot securely in place using standard hardware you likely already have on hand.

What This Model Does

  • Eliminates the need for the double-sided adhesive by mechanically clamping each rubber foot

  • Reuses the original feet and mounting locations

  • Low profile to keep the Core One's sleek look

Hardware Required

  • 4 M3x6 BHCS screws (button head is required for proper clearance)

  • Reuses the 4 existing M3x4rT screws from the Core One base assembly

Print Notes

  • Print in PETG

  • No supports required

  • Recommended settings

    • 20-25% Gyroid infil

    • 4 perimeters

Installation

Place the printer on its side and one corner at a time, remove the M3x4rT screw that holds the 2 bottom profiles at the corner.

Install the holder and screw it with the M3x6 in the original threaded hole and the M3x4rT in the adjacent hole

Push the original Prusa anti-vibration feet into the hole, it should fit snugly and stay in place without the need for adhesive.

Tagi