Razor Shelf - Vigour Mirror Cabinet

The idea

This is a shelf for the inside of a cabinet in the bath room. The cartridges with replacement razor blades will be stored there. 

Because my own original part was to big for the new cabinet, I created this remix.

The shelf shall leave some space below it for other stuff to be stored laying on the ground.

The Cabinet

Unfortunately, I couldn't find an exact type number of the mirror cabinet. Both if others are looking for the hole pattern in a Spiegelschrank by VIGOUR (mirror cabinet) with three doors, maybe this hole pattern helps you for your own design. SPMG140 2025 / 304067698

The shelf

The shelf has six plates that are slightly angled to hold the razor blade cartridges.

The space below the shelf is reserved for other stuff on the ground of the cabinet. 

The column at the back gives the part the necessary stability to avoid it bending down, because the holes are only at the bottom.

The recess in the middle allows easy grabbing of the cartridges.

The wall size of the single shelf is chosen to 1.6 mm to get a stable shelf but that is also fast in printing, because a usual .4 mm nozzle needs four passes.

Print Instructions

The part is prone to warping, because of the long straight lines on top. Add a big brim or distinctive mouse ears at the end of the beams:

Printed in a PLA matching the color of the cabinet. Mount the shelf with four M3x15 TX15 screws.

Modifications Welcome

You'll find the FreeCad File attached.