1 / 5
Hot Wheels Wall Mount (1:64 Diecast Car Display) | No-Drill Adhesive Mounts — zdjęcie 1
1 / 5

Hot Wheels Wall Mount (1:64 Diecast Car Display) | No-Drill Adhesive Mounts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

No-drill wall mount for 1:64 diecast cars (Hot Wheels-size). Uses 1 small Command hook-and-loop strip pair per mount

Ocena
0 / 5
Polubienia
10
Pobrania
76
Wydruki
0
Wyświetlenia
550
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Wall-mounted
Licencja
Creative Commons — Attribution — Noncommercial

Display your 1:64 diecast cars (Hot Wheels-size) on the wall without drilling. This mount is designed around Command hook-and-loop picture hanging strips and holds the car at a clean display angle.

What you need (per mount)

  • 1 pair of Small Command hook-and-loop strips
    (2 total strips — 1 strip on the mount, 1 strip on the wall)

Amazon

Adhesive / Recess tip (IMPORTANT)

This model includes a recess pocket on the back for the strip pads. For best results, it’s recommended to glue the strip pads into the recess so the pad backing can’t peel away from the print over time.

Glue recommendation:

  • Use a small amount of CA (super glue) or epoxy

  • Glue only strip pad → plastic recess (do not glue to the wall)

  • Let cure before mounting

⚠ Note: Gluing the strip pads to the mount may reduce the “easy remove” behavior of some Command products and can increase the chance of wall/paint damage depending on your wall paint/texture. Use at your own discretion.

Fit

  • Designed for most 1:64 diecast cars

  • Sizes vary by casting; intended as a “fits most” display mount.

Print settings (recommended)

  • Material: PLA or PETG (PETG recommended if the room gets warm)

  • Nozzle: 0.4 mm

  • Layer height: 0.20 mm

  • Walls: 3

  • Top/Bottom: 4–5

  • Infill: 15–25%

  • Supports: None

  • Orientation: print flat as modeled

Tagi