Whill F (wheelchair) Footlight

by @CriptasticHacker

Please leave a ❤if you like this design.  It makes me happy :)

My website:

https://cripsrise.neocities.org/

https://hackaday.io/CriptasticHacker

https://www.youtube.com/@CriptasticHacker

Install video here:

Requires these items:

https://www.amazon.com/dp/B0CLGS1JMD  - magnetic foot light "ASOKO Under Cabinet Lights Motion Sensor Light Indoor 3-Colors "

https://www.amazon.com/dp/B0B2WCSX8S- (16x5 Hole 3.5mm)Super strong neodymium magnes  w/screws

Phillips screwdriver (PH2)

small (thin) zip ties

Bonus:

Dremel with cutting bit (to flatten point part of screws after install)

These print great in any PLA! 

Overture Black PLA used (cheap)

I have a very clean PEI build plate and print with the lid on to retain heat inside (makes a big difference for prints sticking when not using gluestick).

Printed on Creality K1C with "expert mode" to enable -0.025mm Z offset for best bed adhesion (squish)

[this can also be changed in printer profile as z offset (within Gcode) if your printer needs it]

Layer height = 0.3mm

Temp = 210-220 c

Bed = 60 c

Standard speeds

Support = tree support

Support x,y distance = 1

Support Z height top distance = 0.3

I also made the support base 100% infill and support line spacing 0