Label Holder - Hydroponic Downspout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is for my eb and flow hydroponic NFT system constructed of downspouts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1/6/26 - UPDATE -
Loaded a new Base and Lid STL file since folks have had issue with trying to get the Lid piece on to the Base. (By folks, I just mean me.)
I developed and constructed an eb and flow, nft, gravity fed hydroponics system from using downspouts. I wanted to start labeling what I was growing so I came up with a simple label holder. Ideally you can place a piece of paper in the holder and tear the excess away, or simply hold custom cuts in place with the teeth.
It is meant to hang over the edge of the downspout as pictured. Place the "hook" end inside your hole for the nft basket.
Quality: .20
Infill: 10%
Support:
Tree Support for the Arm piece
None for the base and lid
Build Plate Adhesion:
Brim for the Arm piece
None for the base and lid
Speed: 60-70
ASSEMBLY:
Arm connects to the Base by sliding on to the middle hinge of the Base. It may take some muscle, but as you get one end on and then slide it on, it should stiffly go on.
Now with the Lid, connect the Lid to the Base hinges.
Once connected, the Lid should move freely back and forth.
Next, grab a piece of paper and put it over the Base and spikes.
Close the Lid completely and tear the excess paper away. (Or you could custom cut paper to fit as well)
If you have any questions, or have questions in regards to hydroponics, please feel free to reach out.
Happy Printing