U1 Spool Holder Hole Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A styled cover to fill the spool holder holes on the Snapmaker U1.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 34
- Wydruki
- 2
- Wyświetlenia
- 182
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a cover that I designed for the Snapmaker U1. It fills the spool holder holes, if the factory holders are not in use. I saw one other model, but it did not appeal to me, visually, and the prongs to snap it into place made the cover too difficult to remove (I broke the test version I printed while trying to remove it).
This one is designed to match the factory waffle pattern. Model is in two parts, so you can assign a different color to each, if desired. These snap directly into place and remove easily with a slight pull, due to the design of the prongs. However, I did include a small notch to allow you to pry it gently (I don't anticipate this being necessary, but it is there, anyway). Install with the notch downward for the most finished look. Recommend printing in PETG for strength and flexibility.