Cord Stress Relief
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3D print designed to take off the stress a charger cable may experience. Works w/ PLA filament. Comments Welcome.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
My charger began to to break, because it was under too much stress. So instead of rearranging my charging set up, I spent 6 hours designing one from scratch. :) Works w/ PLA filament btw. Just be careful taking the print off, making sure not to damage it. Side to side it works fine, but it has trouble in reverse and forward motion. Any ideas to fix that would be welcome.
The hole accommodates for a cable with a diameter of 3.5 mm.
The inner dimensions for iMac USBC Cable Charger Protector are 15x10.5x5.1 mm.
The inner dimensions for Lightning Charger Cable Protector are 32.25x10.5x6.5 mm w/ it shrinking to a width of 7mm that is 23.5mm away from edge.