Spider in a web (combination of two models)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This s just a combination of two nice models (spider and web coaster) to make a nice decoration mounted to a wall
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I used the two models (thanks to the authors) and printed them in different filaments (white web and black spider). I did not change anything in the original models, just scaled them in the slicer. The resulted print however is a very nice decoration and is very simple to print (PLA with standard settings without supports/skirt). I just grinded and glued the models after printing.
There are two web coaster models created by the author - I added both here, you may select the one that will best work for you. I made the web about 2mm in height and about 10cm in width and scaled the spider to fit it adjusting its height a little bit. I really liked the result, although I used a standard 0.2 layer which resulted in a really nice looking.
The only license was suggested by the site considering the licensing of the source models - there is nothing coming from my side.