Spider in a web (combination of two models)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This s just a combination of two nice models (spider and web coaster) to make a nice decoration mounted to a wall
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 38
- Makes
- 0
- Views
- 81
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I used the two models (thanks to the authors) and printed them in different filaments (white web and black spider). I did not change anything in the original models, just scaled them in the slicer. The resulted print however is a very nice decoration and is very simple to print (PLA with standard settings without supports/skirt). I just grinded and glued the models after printing.
There are two web coaster models created by the author - I added both here, you may select the one that will best work for you. I made the web about 2mm in height and about 10cm in width and scaled the spider to fit it adjusting its height a little bit. I really liked the result, although I used a standard 0.2 layer which resulted in a really nice looking.
The only license was suggested by the site considering the licensing of the source models - there is nothing coming from my side.