Hypercube Rear Bed Bracket with Integrated Lead Nut Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've had my thoughts on creating this for a bit. Once I upgraded the z axis rods on the Hypercube from 8mm to 12mm, I…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I've had my thoughts on creating this for a bit. Once I upgraded the z axis rods on the Hypercube from 8mm to 12mm, I think it was time to do so.
This item does a number of things: -Reduces total number of purchased parts -Reduces total number of mount points from 11 to 4 -Increases rigidity -Perfectly vertically aligns the bed mount points to both the lead screw and 12mm axis rods -Reduces guesswork in alignment
To align bracket: -Place Y 2020 extrusions flat against end of bracket -Ensure ends are aligned correctly -Tighten down -Done
I've also created a front bracket which squarely aligns the front of the bed frame. Use it with this. https://www.thingiverse.com/thing:2247321
Well, I just added this one, I remixed the z carriage to have a flat end. This will make it easier to align everything up. https://www.thingiverse.com/thing:4411536
Thanks, all! Jae
Print Settings
Printer:
Hypercube
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.15
Infill:
45
Category: 3D Printer Parts