1 / 2
DIY 6800mAh PD Powerbank Case for 8×17350 Cells (Under $5 Build) — zdjęcie 1
1 / 2

DIY 6800mAh PD Powerbank Case for 8×17350 Cells (Under $5 Build)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D printed powerbank case for 8×17350 cells using a cheap PD module. Compact, powerful, and fully DIY.

Ocena
0 / 5
Polubienia
6
Pobrania
14
Wydruki
0
Wyświetlenia
151
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Public Domain

This project is a compact 3D-printed powerbank enclosure designed for a very affordable and surprisingly powerful DIY build.

The case consists of:

  • Battery box (holds the cells tightly, no glue required)

  • Lid (for the charging module)

  • Soldering aid (to make parallel wiring easier and cleaner)

Battery Setup

  • 8× 17350 vape cells

  • Parallel configuration

  • Each cell: 850 mAh / 3.145 Wh

  • Total capacity: 6800 mAh

  • Output power depends on the charging module used

IMPORTANT:
All cells must be balanced (same voltage) before soldering them together in parallel.
Failing to do so can permanently damage the cells or cause dangerous currents.

Charging Module

The design is made for a commonly available module, easily found on AliExpress by searching for:
"22 5 w powerbank charging module"

  • Supports PD fast charging

  • The module is glued into the lid using epoxy

  • No screws required

Assembly Notes

  • Soldering experience is required

  • The box itself clamps the cells firmly in place

  • The soldering aid helps align and connect the cells cleanly

  • Use proper wire gauge and solid solder joints

Why this project?

With a bit of care and skill, you can give discarded vape batteries a second life by turning them into a 6800 mAh PD powerbank for under $5, using readily available parts and a simple 3D print.
Most of these cells have only seen 10–20 charge cycles out of a potential 500, making this project both cost-effective and environmentally friendly. Perfect for makers who enjoy electronics, DIY energy storage, and compact designs.


Safety Disclaimer

Lithium-ion cells can be dangerous if handled incorrectly.
This project is intended for experienced users only.
Build and use at your own risk.

Tagi