DIY 6800mAh PD Powerbank Case for 8×17350 Cells (Under $5 Build)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printed powerbank case for 8×17350 cells using a cheap PD module. Compact, powerful, and fully DIY.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 14
- Makes
- 0
- Views
- 151
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
This project is a compact 3D-printed powerbank enclosure designed for a very affordable and surprisingly powerful DIY build.
The case consists of:
Battery box (holds the cells tightly, no glue required)
Lid (for the charging module)
Soldering aid (to make parallel wiring easier and cleaner)
Battery Setup
8× 17350 vape cells
Parallel configuration
Each cell: 850 mAh / 3.145 Wh
Total capacity: 6800 mAh
Output power depends on the charging module used
IMPORTANT:
All cells must be balanced (same voltage) before soldering them together in parallel.
Failing to do so can permanently damage the cells or cause dangerous currents.
Charging Module
The design is made for a commonly available module, easily found on AliExpress by searching for:
"22 5 w powerbank charging module"
Supports PD fast charging
The module is glued into the lid using epoxy
No screws required
Assembly Notes
Soldering experience is required
The box itself clamps the cells firmly in place
The soldering aid helps align and connect the cells cleanly
Use proper wire gauge and solid solder joints
Why this project?
With a bit of care and skill, you can give discarded vape batteries a second life by turning them into a 6800 mAh PD powerbank for under $5, using readily available parts and a simple 3D print.
Most of these cells have only seen 10–20 charge cycles out of a potential 500, making this project both cost-effective and environmentally friendly. Perfect for makers who enjoy electronics, DIY energy storage, and compact designs.
Safety Disclaimer
Lithium-ion cells can be dangerous if handled incorrectly.
This project is intended for experienced users only.
Build and use at your own risk.
