Droptop Fender - Funwheel X7
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed my own droptop fender for the Funhweel X7. 2 mini fenders, one droptop, 4 connection pieces
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 548
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The model consists of 7 pieces:
2 mini fenders
1 drop top
4 little connection pieces
I recommend printing the mini fenders in TPU, with 5-6 walls and 15 gyroid infill for a good mix between stiffness and impact strength. (my PETG prototype mini fender cracked after a fall of 30cm/1feet)
As for the Drop top, I have personally printed it in PETG, but I see no reason as to why it wouldn't be better in stiff TPU. After testing so myself, CC3D PBT pro(contains glassfibre - make sure to use hardened nozzle) (can be found on amazon or aliexpres) is probably the best choice. Haven't tested nylon.
The connector pieces would best be printed in PBT pro, but ABS and PLA will hold up just fine too.
They can be glued into the pockets of the drop top fender en will make a snug fit in the matching holes in the mini fenders. I recommend contact glue. Superglue and 2K might me more prone to fractures upon impacts.
The screws of the original fender deletes should still work for these fenders.
Hope they serve you well. Any and all feedback will be appreciated.
:)
Going to try and make a Flatpack drop in fender for in the future. Will update with the Laserfile when I have the chance.
PS. this was designed with the wheel in the position with the most clearance.