V2.4 Revo Nozzle Holder skirt 350mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix made to fit a 350mm Voron 2.4
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Remix to fit a 350mm 2.4 r2
No Supports required
Bill Of Materials
2x 6mm x 3mm Round Magnet
5x M3 Heat-set insert
2x M3x8 SHCS
Instructions
Print skirt and nozzle holder parts (the skirt piece will be placed in the left front position of the printer).
Install the 2 heat-set inserts into the ends of the nozzle holder.
Install one magnet into the skirt and one in the nozzle holder. Be sure they attract each other when the door is installed.
Insert the nozzle holder into the skirt and fasten with two M3x8 BHCS.
Remove the stock skirt from your V2.4 and install the new one in its place. (Note, you'll need to use an angled or ball-end hex driver to install the skirt bolts, as the installed nozzle tray makes it hard to get to).