Focuser Mount for Skywatcher Telescopes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A focuser mount for Nema 17 motors for Skywatcher Telescopes. It fits the most basic focuser.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
The adjustment screws stay accessible with this design. I also accounted for the curvature of the original screw cover. The curvature near the axis allows for 3d printed shaft couplers with longer screws.
The center distance is 54mm
__
BOM required:
1x Nema17
4x M3x16mm (shorter might work, too, but it is untested)
4x M3x8mm
1x Shaft Coupler 4mmx5mm, L25mm (example: https://aliexpress.com/item/1005001538408571.html)
1x Shaft Ø5x~30mm (I used a 5mm brass rod and cut it to length; example: https://aliexpress.com/item/1005009272942522)
1x Small GT2 Pulley 5mm bore
1x Large GT2 Pulley 5mm bore
1x GT2 Belt ( Center Distance is 54mm; use this calculator: https://www.wantabelt.de/en/timing-belt/calculation-program/belt-length-calculator-for-timing-belts-2)
__
For the OnStep configuration:
Steps per micron = [Motor steps] x [Driver microsteps] x [Gear ratio] x [Knob turns needed for max distance] / [Max motion distance in microns]
__
For 3d printed couplers and pulleys, check out:
https://www.printables.com/model/165030-elektronic-focuser-for-newton-or-refractor-with-2-
and
https://www.printables.com/model/333720-gt2-pulley-the-big-collection-updated