1 / 2
Radbody Piranha clips and bumper for OBRC OBZ — zdjęcie 1
1 / 2

Radbody Piranha clips and bumper for OBRC OBZ

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bumpers and clips for the Radbody Piranha body for the OBRC OBZ 1:28 car

Ocena
0 / 5
Polubienia
0
Pobrania
27
Wydruki
0
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I made a front bumper and sideclips for the Radbody Piranha hardbody specifically for the OBRC OBZ 1:28 car. 

The set comes with 2 front lips, one high, one low, and 3 sets of side clips: high, low and very low. The parts are marked with dots: 1 dot is high, 2 dots is low, 3 dots is very low. 

I would normally expect to use either the high or low set together, but by all means experiment. I also included a 3mf file which includes the printer settinsg I used. Used PLA+ filament with a 0.2 nozzle. I haven't tested this with a 0.4 nozzle but it should work. 


Needed to mount the lips to the bumper are 2 M2x10 flathead screws, 2 M2 washers and 2 M2 nuts. 

Tagi